产品中心
新闻动态 当前位置:首页>新闻动态>新闻动态

控制好矿料的含水量

网址:www.luoyangchui.com.cn  2022-05-20  作者:admin    阅读:

停车时要检查锤头与筛条之间、筛条与筛条之间的间隙,必要时进行调整,并定期更换筛条,使其处于适当、合理的范围之内,既要满足生产要求又不能造成积料。破碎机内部间隙主要是指转子体与反击板、篦条及锤头之间的间隙。这些间隙的尺寸关系到蓖条及安全门附近是否有积料。如果积料存在,而锤头无法将积料从蓖条上压下时,锤头就会受到严重的磨损。因此,在使用过程中,必须经常调整各部分间隙,使其处于适当范围之内。
When parking, check the gap between hammer head and screen bar, between screen bar and screen bar, adjust it when necessary, and replace screen bar regularly, so that it can be in an appropriate and reasonable range, which not only meets the production requirements but also can not cause accumulation. The internal clearance of crusher mainly refers to the clearance between rotor body and counterattack plate, grate bar and hammer head. The size of these clearances is related to whether there is accumulation near the castor bars and safety doors. If the accumulated material exists and the hammer can not press the accumulated material down from the castor bar, the hammer will suffer serious wear and tear. Therefore, in the process of use, it is necessary to regularly adjust the clearance of each part so as to keep it within an appropriate range.
控制好矿料的含水量,特别是在雨季生产中,尽量不要铲装地势较低、含水较多的矿料倒入破碎机腔内,有条件的最好在矿石物料进入破碎机之前先进行干燥处理,减少矿石物料中的水分,有助于提高其硬度系数,增大破碎机工作时锤头所受的应力,形成加工硬化层,但是这种方法受破碎物料及场地等要求限制。
Controlling the water content of mineral materials, especially in rainy season production, try not to shovel the mineral materials with lower topography and more water content into the crusher chamber. It is better to dry the mineral materials before they enter the crusher if conditions permit, so as to reduce the water content in the mineral materials, which is helpful to improve the hardness coefficient and increase the crusher. The stress on the hammer head during work forms a work hardening layer, but this method is limited by the requirements of crushing materials and site.

返回新闻

出租电话
13313028229